H3C交换机配置端口聚合

配置vlan

[SwitchA]vlan 10 to 20 

采用动态聚合模式：创建二层聚合接口，并配置动态聚合模式

[SwitchA] interface bridge-aggregation 1

[SwitchA-Bridge-Aggregation1] link-aggregation mode dynamic

[SwitchA-Bridge-Aggregation1] quit

# 分别将端口GigabitEthernet1/0/1至GigabitEthernet1/0/3加入到聚合组1中。

[SwitchA] interface gigabitethernet 1/0/1

[SwitchA-GigabitEthernet1/0/1] port link-aggregation group 1

[SwitchA-GigabitEthernet1/0/1] quit

[SwitchA] interface gigabitethernet 1/0/2

[SwitchA-GigabitEthernet1/0/2] port link-aggregation group 1

[SwitchA-GigabitEthernet1/0/2] quit

[SwitchA] interface gigabitethernet 1/0/3

[SwitchA-GigabitEthernet1/0/3] port link-aggregation group 1

[SwitchA-GigabitEthernet1/0/3] quit

# 配置二层聚合接口1为Trunk端口，并允许VLAN 10和VLAN 20的报文通过。

[SwitchA] interface bridge-aggregation 1

[SwitchA-Bridge-Aggregation1] port link-type trunk

[SwitchA-Bridge-Aggregation1] port trunk permit vlan 10 20

 Please wait... Done.

 Configuring GigabitEthernet 1/0/1... Done.

 Configuring GigabitEthernet 1/0/2... Done.

 Configuring GigabitEthernet 1/0/3... Done.

[SwitchA-Bridge-Aggregation1] quit

2. Switch B的配置

Switch B上的配置与Switch A完全相同，此处不再赘述。

两个交换机连接网线

display link-aggregation verbose

H3C交换机配置端口聚合

原文：http://2338670.blog.51cto.com/2328670/1897479