struct snd_soc_dai_ops接口介绍

CPU DAI和codec DAI 驱动用结构体 struct snd_soc_dai_driver描述，其字段ops的类型是 struct snd_soc_dai_ops，定义了DAI驱动的操作接口。
代码如下：

struct snd_soc_dai_ops {
	/*
	 * DAI clocking configuration, all optional.
	 * Called by soc_card drivers, normally in their hw_params.
	 */
	int (*set_sysclk)(struct snd_soc_dai *dai,
		int clk_id, unsigned int freq, int dir);
	int (*set_pll)(struct snd_soc_dai *dai, int pll_id, int source,
		unsigned int freq_in, unsigned int freq_out);
	int (*set_clkdiv)(struct snd_soc_dai *dai, int div_id, int div);
	int (*set_bclk_ratio)(struct snd_soc_dai *dai, unsigned int ratio);

	/*
	 * DAI format configuration
	 * Called by soc_card drivers, normally in their hw_params.
	 */
	int (*set_fmt)(struct snd_soc_dai *dai, unsigned int fmt);
	int (*xlate_tdm_slot_mask)(unsigned int slots,
		unsigned int *tx_mask, unsigned int *rx_mask);
	int (*set_tdm_slot)(struct snd_soc_dai *dai,
		unsigned int tx_mask, unsigned int rx_mask,
		int slots, int slot_width);
	int (*set_channel_map)(struct snd_soc_dai *dai,
		unsigned int tx_num, unsigned int *tx_slot,
		unsigned int rx_num, unsigned int *rx_slot);
	int (*set_tristate)(struct snd_soc_dai *dai, int tristate);

	/*
	 * DAI digital mute - optional.
	 * Called by soc-core to minimise any pops.
	 */
	int (*digital_mute)(struct snd_soc_dai *dai, int mute);
	int (*mute_stream)(struct snd_soc_dai *dai, int mute, int stream);

	/*
	 * ALSA PCM audio operations - all optional.
	 * Called by soc-core during audio PCM operations.
	 */
	int (*startup)(struct snd_pcm_substream *,
		struct snd_soc_dai *);
	void (*shutdown)(struct snd_pcm_substream *,
		struct snd_soc_dai *);
	int (*hw_params)(struct snd_pcm_substream *,
		struct snd_pcm_hw_params *, struct snd_soc_dai *);
	int (*hw_free)(struct snd_pcm_substream *,
		struct snd_soc_dai *);
	int (*prepare)(struct snd_pcm_substream *,
		struct snd_soc_dai *);
	/*
	 * NOTE: Commands passed to the trigger function are not necessarily
	 * compatible with the current state of the dai. For example this
	 * sequence of commands is possible: START STOP STOP.
	 * So do not unconditionally use refcounting functions in the trigger
	 * function, e.g. clk_enable/disable.
	 */
	int (*trigger)(struct snd_pcm_substream *, int,
		struct snd_soc_dai *);
	int (*bespoke_trigger)(struct snd_pcm_substream *, int,
		struct snd_soc_dai *);
	/*
	 * For hardware based FIFO caused delay reporting.
	 * Optional.
	 */
	snd_pcm_sframes_t (*delay)(struct snd_pcm_substream *,
		struct snd_soc_dai *);
};

struct snd_soc_dai_ops接口介绍

原文：https://www.cnblogs.com/bobfly1984/p/14343034.html