首页 > 其他 > 详细

Porsche Piwis Tester II “No VCI has been detected”,how to do?

时间:2014-12-11 10:14:33      阅读:272      评论:0      收藏:0      [点我收藏+]

Hi,Joy,

I am sorry that my Porsche Piwis Tester II from your shop said “No VCI has been detected” when I was trying to read car ECU. I bought the tool last month and it was the first time that I used it. I tested the USB cable and it worked ok. Is the Porsche diagnostic tool broken? How can I fix the issue? Thanks in advance. Crott.

bubuko.com,布布扣

bubuko.com,布布扣

Hi, Crott,

Did you connect the Porsche Piwis Tester  to the car that you tested? Please note that if there is no communication between the vehicle and the tool, info of the ECU module is invisible. Please follow the instruction below:

First plug the OBDII cable to Piwis Tester 2 and DLC of the car.

Second, connect turn the ignition key to “On” to start the vehicle.

Third, connect the tool to a PC via a USB cable.

Finally Run the software and check if there is data in ECU and other systems.

If there is data in the systems, it means the communication is built and the warning message should be gone.

Best regards,

Eobd2

Porsche Piwis Tester II “No VCI has been detected”,how to do?

原文:http://www.cnblogs.com/mike88992/p/4156834.html

(0)
(0)
   
举报
评论 一句话评论(0
关于我们 - 联系我们 - 留言反馈 - 联系我们:wmxa8@hotmail.com
© 2014 bubuko.com 版权所有
打开技术之扣,分享程序人生!